DeWalt DWE305 Traduction De La Notice D'instructions Originale page 8

All manuals and user guides at all-guides.com
ENGLISH
Mains Plug Replacement
(Middle East and Africa)
If a new mains plug needs to be fitted:
• Safely dispose of the old plug.
• Connect the brown lead to the live terminal in
the plug.
• Connect the blue lead to the neutral terminal.
WARNING: No connection is to be
made to the earth terminal.
Follow the fitting instructions supplied with good
quality plugs. Recommended fuse: 13 A.
Using an Extension Cable
If an extension cable is required, use an approved
3–core extension cable suitable for the power input
of this tool (see Technical Data).The minimum
conductor size is 1.5 mm 2 ; the maximum length
is 30 m.
When using a cable reel, always unwind the cable
completely.
ASSEMBLY AND ADJUSTMENTS
WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
before adjusting or changing set-
ups or when making repairs. Be sure
the trigger switch is in the OFF position.
An accidental start-up can cause injury.
Mounting the Saw Blade (fi g. 2)
1. Move the blade clamp lever (b) up to release
the blade clamping mechanism.
2. Insert the saw blade into the holder (d) until it
engages. The blade can be installed with the
teeth pointing down or up, or left or right.
3. Move the blade clamp lever (b) down to lock the
blade clamping mechanism.
4. To remove the saw blade, proceed in reverse
order.
Saw Blades
Material Recommended Saw Blade
ferrous metal fine-toothed
non ferrous metal coarse-toothed
wood coarse-toothed
plastic fine-toothed
masonry carbide-tipped
6
A wide variety of dedicated saw blades is available
as an option.
WARNING: Always select your saw
blade with great care.
OPERATION
Instructions for Use
WARNING: Always observe the safety
instructions and applicable regulations.
WARNING: To reduce the risk
of serious personal injury, turn
tool off and disconnect tool from
power source before making any
adjustments or removing/installing
attachments or accessories.
WARNING:
• Ensure the material to be sawn is
secured in place.
• Apply only a gentle pressure to the
tool and do not exert side pressure
on the saw blade. If possible, work
with the saw shoe pressed against
the workpiece. This prevents damage
to the blade and stops the tool from
jerking and vibrating.
• When sawing in walls or doors be
aware of the location of pipework and
wiring. Always hold the tool by its
handle.
• Avoid overloading.
• Let the blade run freely for a few
seconds before starting the cut. Never
switch on the tool when the saw
blade is jammed in the workpiece or in
contact with the material.
Proper Hand Position (fi g. 1, 4)
WARNING: To reduce the risk of
serious personal injury, ALWAYS use
proper hand position as shown.
WARNING: To reduce the risk of
serious personal injury, ALWAYS hold
securely in anticipation of a sudden
reaction.
Proper hand position requires one hand on the back
handle (g), with the other hand on the front grip (e).
Switching On and Off (fi g. 1)
To run the tool, press the variable speed switch (a).
The pressure exerted on the variable speed switch
determines the tool speed.