SANNOVER 5010 DITA Manuel D'instructions page 18

THE OVEN SHOULD ONLY BE USED FOR COOKING. IT CANNOT BE USED FOR HIDING AND STORAGE PURPOSES. DO NOT EXCEED THE
TIMES AND TEMPERATURES IN THE TABLE FOR COOKING AT BELOW). IT IS NOT USE FOR BARBEQUE PURPOSE. HEAT RESISTANT
KITCHEN EQUIPMENT MUST BE USED.
GENERAL PRECAUTIONS
Producer responsibility is limited to the supply of the appliance.
The installation must be carried out scrupulously according to the instructions provided in this manual and the rules of the profession.
Installation must only be carried out by a qualified technician who works on behalf of companies suitable to assume the entire
responsibility of the system as a whole.
Producer declines any responsibility for the product that has been modified without written authorization as well as for the use of
non-original spare parts.
It is OBLIGATORY to respect the National and European rules, local regulations concerning building matter and also fireproof rules.
! NO MODIFICATIONS CAN BE CARRIED OUT TO THE APPLIANCE. Producer cannot be held responsible for lack of respect for such
precautions.
INSTALLATION REGULATIONS
Installation of the Product and auxiliary equipment in relation to the heating system must comply with all current Standards and
Regulations and to those envisioned by the law.
The installation and the relating to the connections of the system, the commissioning and the check of the correct functioning must be
carried out in compliance with the regulations in force by authorized professional personnel with the requisites required by the law,
being national, regional, provincial or town council present in the country within which the appliance is installed, besides these present
instructions.
Installation must be carried out by authorized personnel who must provide the buyer with a system declaration of conformity and will
assume full responsibility for final installation and as a consequence the correct functioning of the installed product.
The Product, assembled and ready for the installation, must be connected with a junction to the existing flue of the house. The junction
must be possibly short, straight, horizontal or positioned a little uphill. The connections must be tight.
Before installing the appliance, carry out the following checks:
▪ UPPER smoke output.
▪ Verify if your structure can support the weight of the appliance. In case of insufficient carrying capacity it is necessary to adopt
appropriate measures, Producer responsibility is limited to the supply of the appliance (See chapter TECHNICAL DESCRIPTION).
▪
Make sure that the floor can support the weight of the appliance (for ex. distributing weight plate), and if it is made of flammable
material, provide suitable insulation (DIMENSIONS ACCORDING TO REGIONAL REGULATIONS).
▪ Make sure that there is adequate ventilation in the room where the appliance is to be installed, with particular attention to windows
and doors with tight closing (seal ropes).
▪ Do not install the appliance in rooms containing collective ventilation ducts, hoods with or without extractor, type B gas appliances,
heat pumps, or other appliances that, operating at the same time, can put the room in depression.
▪ Make sure that the flue and the pipes to which the appliance will be connected are suitable for its operation. It is NOT allowed the
connection of various appliances to the same chimney.
▪ The diameter of the opening for connection to the chimney must at least correspond to the diameter of the flue gas pipe. The
opening must be equipped with a wall connection for the insertion of the exhaust pipe and a rosette.
▪ The installation must be appropriate and has to allow the cleaning and maintenance of the product and the flue.
! Producer declines all responsibility for damage to things and/or persons caused by the system. In addition, it is not responsible for
any product modified without authorization and even less for the use of non original spare parts.
Your regular local chimney sweep must be informed about the installation of the appliance so that he can check the correct connection
to the chimney
18
GB