Beko BKS 1350 T Manuel D'utilisation page 10

4 Cleaning and maintenance
3. Open the dust container cover (6) by turning
it counter-clockwise. Remove the cyclone
assembly (18), foam filter (20) and motor
protection filter (19).
4. Wash the cyclone assembly (18) in warm water,
if required. Wait until the cyclone assembly is
dried.
5. Clean the dust container (4) with a damp cloth,
if required.
6. Replace the cyclone assembly (18), foam filter
(20) and motor protection filter (19) in their
places and close the upper cover so that it is
seated with a click.
7. Make sure that all components are completely
dried before installing all components to the
appliance and switching on the appliance.
A
WARNING: Dry the filters outdoors.
Never use any source of heat to dry
the filters.
10 / 57 EN
All manuals and user guides at all-guides.com
8. To remove the dust blocking the filter, gently tap
9. Lightly tap across the filter to remove excessive
10. Repeat this process 4 times and wait until it is
the hepa output filter on a hard surface. Wash
the filter in warm water.
water.
completely dried by itself naturally. Do not use
any heating device for drying.
Vacuum cleaner / User manual