Publicité
Les langues disponibles
Les langues disponibles
Using the appliance
Ironing
Temperature setting
SYNTH to
to LINEN
Place the appliance on a stable and even surface.
Note: In order to ensure safe ironing we recommend to always place the base on a stable ironing board.
Make sure that there is enough water in the water tank.
Remove the mains cord and water supply hose from the storage compartment.
4 Put the mains plug in an earthed wall socket and press the on/off switch to switch on the appliance.
5 Turn the temperature dial to set the appropriate temperature according to the table above. The
appliance adjusts the steam automatically depending on the temperature chosen.
Note: refer to the garment label for recommended temperature setting. Do not iron non-ironable fabrics.
6 Wait until the 'iron ready' light lights up continuously )Fig. 4(. This takes about 2 minutes.
7 For GC6730 series only: press the carry lock release button to unlock the iron from the iron platform
(Fig. 5).
8 Press and hold the steam trigger to start ironing (Fig. 6).
Warning: Never direct steam at people.
Note: When you use the appliance for the first time, it may take 30 seconds for steam to come out of the
appliance.
Note: The pump is activated each time you press the steam trigger. It produces subtle rattling sound,
which is normal. When there is no water in the water tank, the pump sound is louder. Fill up the water
tank with water when the water level drops below the minimum level.
Steam boost function
Press the steam trigger twice quickly to release a powerful boost of steam for 3 seconds )Fig. 7(.
Note: it is recommended to use the steam boost function only for stubborn crease.
Vertical ironing
Warning: Hot steam is emitted from the iron. Never attempt to remove wrinkles from a garment while
someone is wearing it (Fig. 8). Do not apply steam near your or someone else's hand.
You can use the steam iron in vertical position to remove wrinkles from hanging fabrics.
Hold the iron in vertical position, press the steam trigger and touch the garment lightly with the soleplate
and move the iron up and down (Fig. 9).
Auto shut-off
-
The appliances enters the standby mode if it has not been used for 15 minutes. The "iron ready" light
starts to flash.
-
To activate the appliance again, press the steam trigger. The appliance starts to heat up again.
-
The appliance switches off automatically if it has not been used for another 10 minutes after it enters the
standby mode. The "iron ready" light goes off.
Automatic steam setting
Fabric type
Synthetic fabrics )e.g., acetate, acrylic, nylon,
viscose, polyamide, polyester(
Silk, wool
Cotton, linen
English
7
Publicité
