Publicité
Les langues disponibles
Les langues disponibles
CP 0222
Fitting and removing the insertion tool
Whenever fitting or removing the insertion tool the
following instructions must be observed:
1. To prevent an accidental start: switch off the
power supply and bleed the machine by
pressing the start and stop device. Disconnect
the machine from the power source.
2. Before inserting a tool, lubricate the tool shank
with grease.
3. Fit or remove the insertion tool.
4. Close the tool retainer (position A) and check
the lock function by tugging the inserted tool
sharply outwards.
Operation
WARNING
Involuntary start
Involuntary start of the machine may cause injury.
Keep your hands away from the start and stop
►
device until you are ready to start the machine.
Learn how the machine is switched off in the event
►
of an emergency.
Stop the machine immediately in all cases of
►
power supply interruption.
9800 0550 90a | Original instructions
Safety and operating instructions
Start and stop
Start the machine by squeezing the trigger while
firmly holding the handle.
Stop the machine by releasing the trigger. The
trigger returns automatically to the stop position.
Operating
Starting a cut
Stand in a stable position with your feet well away
♦
from the inserted tool.
Press the machine against the working surface
♦
before you start.
Start collaring at such a distance from the edge
♦
that the machine is capable of breaking the
material without levering.
♦
Never try to break off too large pieces. Adjust the
breaking distance (A) so that the inserted tool
does not get stuck.
15
Publicité
