Introduction; Manual Purpose And Contents; Target; How To Keep This Manual - KENT Edge 28B Instructions D'utilisation

ENGLISH

INTRODUCTION

NOTE
The numbers in brackets refer to the components shown in Machine Description chapter.

MANUAL PURPOSE AND CONTENTS

The purpose of this Manual is to provide the operator with all necessary information to use the machine properly, in a safe and
autonomous way. It contains information about technical data, safety, operation, storage, maintenance, spare parts and disposal.
Before carrying out any procedure on the machine, the operators and qualifi ed technicians must read this Manual carefully. Contact
Kent in case of doubts regarding the interpretation of the instructions and for any further information.

TARGET

This Manual is intended for operators and technicians qualifi ed to perform the machine maintenance.
The operators must not carry out procedures reserved for qualifi ed technicians. Kent will not be responsible for damages coming
from the non-observance of this prohibition.

HOW TO KEEP THIS MANUAL

The Instructions for use Manual must be kept near the machine, inside an adequate case, away from liquids and other substances
that can cause damage to it.

IDENTIFICATION DATA

The machine model and serial number are marked on the plate (33).
The machine production year is indicated by the fi rst two fi gures of the machine serial number.
This information is useful when requiring machine spare parts. Use the following table to write down the machine identifi cation data.
MACHINE model ...............................................................................
MACHINE serial number ...................................................................

OTHER REFERENCE MANUALS

– Spare Parts List (supplied with the machine)
– Service Manual (that can be consulted at Kent Service Centers)

SPARE PARTS AND MAINTENANCE

All necessary operating, maintenance and repair procedures must be carried out by qualifi ed personnel or by Kent Service Centers.
Only original spare parts and accessories must be used.
Contact Kent for service or to order spare parts and accessories, specifying the machine model and serial number.

CHANGES AND IMPROVEMENTS

Kent constantly improves its products and reserves the right to make changes and improvements at its discretion without being
obliged to apply such benefi ts to the machines that were sold previously.
Any change and/or addition of accessory must be approved and performed by Kent.

OPERATION CAPABILITIES

This sweeper has been designed and built to clean (by sweeping and vacuuming) smooth and solid fl oors, in civil and industrial
environments and to collect dust and light debris under safe operation conditions by a qualifi ed operator.

CONVENTIONS

Forward, backward, front, rear, left or right are intended with reference to the operator's position, that is to say with the hands on the
handlebar (6).
2
INSTRUCTIONS FOR USE
146 3082 000(3)2008-11 Edge 28B