Side Broom Height Check And Adjustment; Side Broom Disassembly/Assembly - KENT Edge 28B Instructions D'utilisation

SIDE BROOM HEIGHT CHECK AND
ADJUSTMENT
1. Check that the side broom is at the correct height from the
ground, according to the following procedure:
• Drive the machine on a level ground and lower the side
broom.
• Keep the machine stationary and turn on the side
broom for a few seconds.
• Turn off the side broom by pressing the switch (1), then
lift it and move the machine.
• Check if the size and orientation of the print left by
the side broom are as shown in the fi gure (A, Fig. 1):
the side broom must touch the ground along a circle
arc ranging from "10 o'clock" position to "3 o'clock"
position.
• If the print is not within specifi cations, it is necessary
to adjust the broom height, according to the procedure
shown in step 2.
2. Turn the knob (13) clockwise or counter-clockwise to
adjust the broom height up or down.
3. Perform step 1 again to check that the side broom is at the
correct height from the ground.
4. When the broom is too worn and can no longer be
adjusted, replace it according to the procedure shown in
the following paragraph.

SIDE BROOM DISASSEMBLY/ASSEMBLY

CAUTION!
It is advisable to use protective gloves when
replacing the side broom because there can be
sharp debris between the bristles.
1. Drive the machine on a level ground.
2. Turn the main switch (1) to "0".
3. Lift the side broom.
4. Loosen the knob (A, Fig. 2) inside the side broom, then
remove the broom (B) by disengaging it from the pins (C).
5. Install the new broom on the machine engaging it on the
pins (C), then tighten the knob (A).
6. Adjust the height of the new broom according to the
procedure shown in the previous paragraph.
INSTRUCTIONS FOR USE
B
Edge 28B 146 3082 000(3)2008-11
ENGLISH
10
A
Figure 1
C
A
Figure 2
11
3
S311350
S311351