Main Broom Height Check And Adjustment - KENT Edge 28B Instructions D'utilisation

ENGLISH
MAIN BROOM HEIGHT CHECK AND
ADJUSTMENT
1. Check that the main broom is at the correct height from the
ground, according to the following procedure:
• Drive the machine on a level ground.
• Keep the machine stationary and turn on the main
broom for a few seconds.
• Turn off the main broom by pressing the switch (1),
then move the machine.
• Check that the main broom print (A, Fig. 3), along its
length, is 1.2-2 in (3-5 cm) wide.
• If the print is not within specifi cations, it is necessary
to adjust the broom height, according to the procedure
shown in step 2.
2. Turn the main switch (1) to "0".
3. On both sides of the machine, loosen the knob (A, Fig. 4).
4. Grasp the support (B) on the points (C) and move it
upwards, then lift it or lower it to change the main broom
height. For height variation, refer to the indicator (D). Then
tighten the knob (A) on both sides of the machine.
5. Perform step 1 again to check that the main broom is at
the correct height from the ground.
6. When the broom is too worn and can no longer be
adjusted, replace it according to the procedure shown in
the following paragraph.
CAUTION!
An excessive print (larger than 2 in (5 cm)) of the
main broom can lead to machine malfunction and
overheating of moving and electric parts, thus
reducing machine life.
Pay careful attention when performing the above-
mentioned checks, and always use the machine
according to the indicated conditions.
12
INSTRUCTIONS FOR USE
146 3082 000(3)2008-11
C
D
B
Edge 28B
Figure 3
A
C
Figure 4
S311352
S311353