Setting The Clock; Eco Function; Radio Operation - iSymphony M110 Manuel D'utilisation

Setting the Clock

When the AC power is connected, "AM 12:00" will appear on the display.
The clock can only be set while the unit is off.
Press the PROG/CLK button, the "AM" and hour digits begin to flash.
Press the SKIP/TUNING or
Press the PROG/CLK button to confirm. The minute digits begin to flash.
Press the SKIP/TUNING or
Press the PROG/CLK button to confirm.
Note: This unit uses 12 hour time format only.

ECO Function

You can select whether or not the clock is displayed while the unit is in standby mode. Selecting
ECO mode means the unit will use less electrical power while in standby mode.
To turn the clock display off:
Hold the SLEEP/ECO button for 3 seconds while the unit is in standby
mode. Display shows "ECO ON" and clock display disappears.
To turn the clock display on:
Hold the SLEEP/ECO button for 3 seconds while the unit is in stand
by mode. Display shows "ECO OFF" and clock display appears.
buttons to adjust the hour.
buttons to adjust the minute.
17

RADIO OPERATION

Press the FUNCTION button repeatedly until the main display shows "TUNER".
AM or FM frequency will appear on the display.
Press the STOP/BAND button to switch between the AM and FM bands.
Tune to the desired station as follows:
Manual Tuning
Repeatedly press the SKIP/TUNING
frequency of the desired station. Use the Manual Tuning method to tune to weak or distant
stations that are not strong enough to be recognized by the Automatic Tuning system.
Automatic Tuning
Depress and hold the SKIP/TUNING
release the buttons. The Tuner will search up or down the band for the next strong signal and
stop on that station. Repeat this procedure until the tuner stops on your desired station.
FM Stereo signal is indicated by the "ST" indicator.
If the FM Stereo reception is noisy or weak:
Press the ST/MONO button on the remote control to select FM
Mono mode.
or buttons until the display shows the exact
or buttons until the display begins to move, then
18