Setting The Clock - iSymphony M1 Manuel D'utilisateur

Setting The Clock

When the unit is connected to the AC outlet for
the first time the "– –:– –" flashes on the display.
Note: Do not turn the main unit power 'On'. The clock can only be set while
the main unit power is 'Off'. The clock can only be set with the Remote Control.
1.) Press and hold the PROGRAM/CLOCK button on the remote control.
"12 HOUR" flashes on display.
Press the SKIP/TUNING + or – buttons to
select between "24 HOUR" or "12 HOUR"
modes if necessary.
2.) Press the PROGRAM/CLOCK button again.
Just the Hour digits will continue flashing.
3.) Press the SKIP/TUNING + or – buttons to set the display to the correct hour,
AM or PM.
4.) Press the PROGRAM/CLOCK button again.
The Minute digits will begin flashing.
5.) Press the SKIP/TUNING + or – buttons to set the display to the correct minutes.
6.) Press the PROGRAM/CLOCK button once
more. Only the ":" flashing and the clock
begins to run.
1