Maintenance And Service - Enviro Q3LI Manuel Du Propriétaire

Masquer les pouces Voir aussi pour Q3LI:

Manuel du propriétaire (49 pages)

Table Des Matières

Table des Matières

Conversion Kit Installation:

Turn the unit off by pressing the ON/OFF Key on the remote and shut off gas supply at the shut-off

valve upstream of the unit. CAUTION: The gas supply must be shut off prior to disconnecting the

electrical power and before proceeding with the conversion. Allow the valve and unit to cool down

to room temperature.

Remove the glass door as shown in the M

Carefully remove the log set and fire grate.

Remove the burner as shown in the M

Figure A. Venturi Adjuster Replacement

Convert the Venturi Adjuster supplied with your kit.

a) Remove the current Venturi Adjuster using a T20 Screwdriver. When removing the Adjuster be

careful not to lose the pair of aluminum spacers.

b) Replace the Adjuster with the one supplied in your conversion kit and assemble it all back

together; do not over tighten the T20 screws and ensure the adjuster slides with little resistence on

STATION 1

STATION 2

the Venturi Housing.

STATION 3

STATION 4

Convert the pilot injector (see Figure 23):

a) Using a

b) Push the slider with your finger or flat head screwdriver

- Natural Gas is marked NAT.

- Propane gas is marked LP with an indicating hole between L and P. It is also marked red.

c) Turn the pilot head a

Convert the burner orifice:

a) Remove the main burner orifice with a

b) Replace the NG orifice with the LP orifice. Do not over-tighten. The LP orifice hole will always be

smaller then the NG hole.

Convert the SIT gas valve:

a) Use a T-20 driver to remove the two screws that hold the stepper regulator to the gas valve and

disconnect the wire harness from the IFC.

b) Remove the rubber regulator diaphragm that is situated between the stepper regulator and the valve

body. The new stepper regulator already has this diaphragm installed.

Page 18