Complete The Installation - Hisense Rf21A3Fse Guide D'utilisation Et D'entretien

Table des Matières
Les langues disponibles

Les langues disponibles

9. If necessary, use a hex-key wrench to remove the two
bolts fastening the bottom hinge to the front of the
cabinet, and then remove the hinge.
10. Repeat this procedure to remove the other door.
Remove the Front of the Freezer Drawer
1. Slide open the freezer drawer to its full
extension.
2. Slide open the upper storage drawer to its full
extension.
Remove the upper storage drawer from the glide rails
3.
by lifting up and pulling out at an angle.
Remove the lower storage compartment by lifting
4.
upward at an angle.
Remove one fixing screw (left and right
5.
each) from the side of the slide rail.
a Screws
Grab the drawer door by using both hands and
6.
pull it up to make sure the door detaches
from the front of the slide rail and then move
forward to remove the freezer drawer door.
Set the drawer front on a soft surface to
7.
protect the fi nish.
Slide the drawer glide rails into the cabinet.
8.
Move the refrigerator through the doorway and into
9.
the room near the water and electrical connections.
Replace the Doors
1. If removed, reinstall the bottom hinge.
2.
3. Insert the top hinge into the top of the door.
4.
5. Repeat steps 1 through 4 to replace the
6.
IMPORTANT: The refrigerator must be located on a
solid, level surface that is strong enough to support
the refrigerator fully loaded.
a

Complete the Installation

1. Plug into a grounded 3 prong outlet.
2. Move the refrigerator into its final location, making sure
Using two or more people, set the refrigerator door
onto the bottom hinge.
Using the three screws removed earlier, fasten the
top hinge to the top of the cabinet.
NOTE: Left-hand door only, replace the ground
screw into the top hinge.
opposite door.
Using the three screws removed earlier, reinstall the
top hinge cover and control panel to the top of the
cabinet.
Before moving, retract the leveling legs to
avoid scraping the floor.
The refrigerator has wheels, which should be used
for only forward and backward movement.
NOTE: Trying to move the refrigerator sideways may
damage your floor.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove the ground prong from the
power cord plug.
Do not use an adapter.
Do not use an extension cord.
Failure to do so can result in death, fire or
electrical shock.
NOTE: This refrigerator begins operating as
soon as it is connected to the power supply.
to maintain the recommended clearance.
8

Chapitres

Table des Matières
loading

Table des Matières