Publicité
Les langues disponibles
Les langues disponibles
Door Removal
(only if needed)
Measure the refrigerator to make sure it will fi t through the
doorway. If the refrigerator cannot pass easily through the
doorway, follow the instructions to remove the two
refrigerator compartment doors and the front panel of the
freezer drawer.
WARNING
Electrical Shock Hazard
Disconnect power before removing doors.
Reconnect ground wire before operating.
Failure to do so could result in death or
electric shock.
Tools needed
Phillips Screwdriver
•
4 mm Hex-key Wrench
•
8 mm Socket Wrench
•
Remove the Doors
IMPORTANT:
Keep the refrigerator doors closed until you
are ready to lift them from the cabinet.
1. Unplug refrigerator or disconnect power.
Using a Phillips screwdriver, remove the three
2.
screws attaching the hinge cover and control panel to the
top of the cabinet.
a Screws
b Hinge Cover
3. Gently lift the hinge cover, keeping the wire harness
attached, and move the cover/wire harness assembly
behind the door hinges on the cabinet top.
Disconnect the harness from the door by
4.
using a release clip on the harness connector, then
separate the two ends(only the left side).
7
a
b
a
Wiring Hamess
5. Using an 8mm socket wrench,remove
the three screws fastening the top hinge
to the cabinet.
a
NOTE: Provide additional support for the door while the
hinge is being removed. Do not depend on the door
gasket magnets to hold the door in place while you are
working.
6. Remove the top door hinge.
IMPORTANT: For the door to close properly in the future,
DO NOT lift the door from the bottom hinge if it is open to
an angle narrower than a 90° angle.
7. Open the door to a 90° or wider angle.
Using both hands, lift the door off the bottom hinge
8.
and set it onto a soft surface to protect the fi nish.
Screws
90°
a
a
Publicité
