Télécharger Imprimer la page

Hisense RF21A3FSE Guide D'utilisation Et D'entretien page 5

Publicité

Les langues disponibles

Les langues disponibles

Installation Requirements
Location Requirements
WARNING
Explosion and Fire Hazard
Keep flammable materials and vapors, such as
gasoline, away from appliance.
Failure to do so can result in death, explosion or fire.
IMPORTANT: This refrigerator is designed for
indoor, household use only.
Temperature
This refrigerator is intended for use in a location where the
temperature ranges from a minimum of 55°F (13°C) to a
maximum of 110°F (43°C). The preferred room temperature
range for optimum performance, which reduces electricity
usage and provides superior cooling, is between 60°F (15°C)
and 90°F (32°C). It is recommended that you do not install
the refrigerator near a heat source, such as an oven or
radiator.
Ventilation
Adequate air circulation around the refrigerator is
required for efficient operation.
To ensure proper ventilation, maintain the
recommended clearances.
Recommended Clearances
a
b
c
a 4" Above(From top of the door)
b 2" Behind
c 1" Each Side
NOTE: If you place the refrigerator next to a fixed wall, leave
10" minimum space to allow the door to swing open.
5
c
Electrical Requirements
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove the ground prong from the
power cord plug.
Do not use an adapter.
Do not use an extension cord.
Failure to do so can result in death, fire or
electrical shock.
Before you move your refrigerator into its final location, it is
important to make sure you have the proper electrical
connection.
Recommended Grounding Method
A 115 volt, 60 Hz, AC only 15- or 20-amp fused, grounded
electrical supply is required. It is recommended that a
separate circuit serving only your refrigerator be provided.
Use an outlet that cannot be turned off by a switch. Do not
use an extension cord.
NOTE: Before performing any type of installation or
cleaning, disconnect the refrigerator from the electrical
source. When you are finished, reconnect the refrigerator to
the electrical source and reset the temperature controls to
the desired setting.

Publicité

loading