Dirt Devil DD9001 Manuel D'instructions page 12

6. Possible problem and solution
This chapter summarizes the most common problems you could encounter with the
appliance. If you are unable to solve the problem with the information below, contact the
Consumer Care Centre in your country.
Problem
The appliance does
not work
The charging light
does not go on
The vacuum cleaner
does not vacuum
properly
Dust escapes from
the vacuum cleaner.
The vacuum cleaner
does not work
properly when one
of the attachments is
attached to the small
plastic brush.
The appliance
produces a lot of
noise
Cause
The batteries may be low
1. You may not have put the
adapter in the wall socket
properly.
2. Product has not been
connected with power supply
3. You may not have placed
the appliance on the charger
properly.
4. The contact points on the
appliance and/or on the
charger may be dirty.
5. The appliance may have been
switched on while it was on
the charger.
1. The dust compartment
may not be attached to the
appliance properly.
2. The dust compartment may
be full.
3. The filter unit in the dust
compartment may be clogged.
1. The dust compartment may
be full.
2. The dust compartment
may not be attached to the
appliance properly.
3. Perhaps the filter unit is
not placed in the dust
compartment properly.
1. Check if the attachment is
blocked.
2. The dust compartment may
be full.
3. The filter unit may be clogged.
There may be solid particles in
the dust compartment.
Solution
Recharge the batteries.
1. Put the adapter in the wall
socket properly.
2. Make sure that the
appliance plug is inserted
into the appliance properly
and that the appliance is
switched off
3. Place the appliance on the
charger properly and make
sure that the charging light
goes on.
4. Wipe them clean with a dry
cloth.
5. Make sure that the
appliance is switched off
when you charge it.
1. Attach the dust compartment
to the appliance properly.
2. Empty the dust
compartment.
3. Clean both parts of the filter
unit.
1. Empty the dust
compartment.
2. Attach the dust compartment
to the appliance properly.
3. Place the filter unit in the
dust compartment properly.
1. If this is the case, remove
the obstruction.
2. Empty the dust
compartment. Clean both
parts of the filter unit.
Empty the dust compartment.