Publicité
Les langues disponibles
Les langues disponibles
BURNER – Extreme care should be taken when removing and replacing a burner. It must be correctly centered on the orifice
before any attempt is made to relight the grill. Frequency of cleaning will depend on how often you use the grill.
Failure to properly place the burner over the orifice could cause a fire to occur behind and beneath the valve panel, thereby
damaging the grill and making it unsafe to operate. Before cleaning, make sure that the gas container is disconnected from
regulator and the grill have cooled down.
STEP 1
To remove the burner for cleaning:
1. Use adjustable wrench to remove orifice/regulator hose assembly from burner.
2. Remove flame tamer and locate the burner screw on the left side of the firebox.
3. Remove the screw.
4. Lift the burner out of the firebox.
STEP 2
To clean the grill burner:
1. Clean the exterior of the burner with a wire brush. Use a metal
scraper for stubborn stains or debris.
2. Clear clogged ports with a straightened paper clip. Never use
a wooden toothpick as it may break off and clog the port.
3. Check and clean burner / venturi tube for insects and insect
nests. A clogged tube can lead to a fire beneath, and behind
the main control panel.
CLEANING
26
Publicité
