Andis PM-1 Instructions D'utilisation Et D'entretien page 3

damaged, or dropped into water. Return the appliance to an
All manuals and user guides at all-guides.com
Andis authorized service station for examination.
6. Keep the cord away from heated surfaces.
7. Never drop or insert any object into any opening.
8. Do not use outdoors or operate where aerosol (spray) products
are being used or where oxygen is being administered.
9. Do not use this appliance with a damaged or broken blade or
comb, as injury to the skin may occur.
10. To disconnect turn control to "OFF" then remove plug from
outlet.
11. WARNING: During use, do not place or leave appliance
where it may be (1) damaged by an animal or (2) exposed to
the weather.
12. This appliance is intended for trimming purposes only.
SAVE THESE INSTRUCTIONS
THIS PRODUCT INTENDED FOR HOUSEHOLD USE
OPERATING INSTRUCTIONS
To reduce the risk of electric shock, this appliance has a polarized plug (one blade is
wider than the other). This plug will fit in a polarized outlet only one way. If the plug
does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a
qualified electrician to install the proper outlet. Do not change the plug in any way.
Before starting clipper remove blade guard. Plug cord into electrical outlet, operate at
120 volt, 60 cycle AC electrical current or as noted on the unit. To start clipper move
switch button to "ON" position, to stop, move switch button back to original position.
After using your Andis clipper, rewrap cord and store in a safe place.
USING THE ATTACHMENT COMBS
(Some models do not have combs and sizes will vary by kit)
You can set the blades for a longer cut by using any of the attachment combs made
for your Andis clipper. The combs mount easily; simply slip the cutter blade teeth into
comb and snap the comb down (Figures A & B). To remove, simply snap off. These
attachment combs guide hair into the blades and give you precise control of hair
lengths. The length of trim is indicated on the attachment comb. Use the chart to find
the approximate lengths of cut. Different blade angles in relation to the skin, thickness
and texture of the hair will vary the cutting length.
CLIPPER BLADE ADJUSTMENT
Your Andis adjustable clipper blade set is easy to adjust. From short to longer cuts,
all that is needed is a flick of the adjustment lever with your thumb. In the upright
position, the blades are set for the shortest cuts (Figure C).
3