Publicité
3.7. Similarly, in the same way and insert the hook for hanging the navitiya power cable. Press
the hook to the body of high pressure cleaner in a specified location on the lower figure B and drag
down.
B
C
Filter should always be installed to protect the valves and other components of high pressure
cleaner of sand, limestone deposits and other particulate matter that can damage it. So check the
filter for contamination and clean it if necessary.
Note: If not installed filter the security lapse. The temperature of the water supply should not
exceed 40 ° C. Water power must have the following parameters: working pressure of 3 bar and a
minimum internal diameter of 13 mm (1 / 2''). Suitable garden hose with a diameter of 1 / 2 "long and
5 to maximum 25 m (not included in the complete set). Water must be clean and free of sand and
corrosive substances. Work in a dry (no water) can cause damage to high pressure cleaner. Before
placing the trigger of the pistol grip must be pressed to remove air from the pump and pressure
tank.
3.7. Connect high pressure hose to nozzle.
3.8. Install the extension, insert it into the spray gun and Screw it.
All manuals and user guides at all-guides.com
15
Publicité
