EGAmaster EGATRONIK Manuel D'instructions page 31

Note
- For testing the capacitor with polarity, connect the red test lead to anode & black test lead to
cathode.
- When the tested capacitor is shorted or the capacitor value is overloaded, the LCD display
- To minimize the measurement error caused by the distributed capacitor, the testing lead or
testing clip should be as short as possible.
- It is normal to take a while for zeroing when changing over the measurement range. This
process will not affect the accuracy of the final readings obtained.
Sleep Mode
To preserve battery life, the Meter automatically turns off if you do not turn the rotary switch or
press any button for around 10 minutes. At that time, the Meter consumes around 10µA current.
The Meter can be activated by pressing the POWER two times.
Turning on the Auto Display Backlight
The Meter has a built-in sensor. Therefore the Display Backlight turns on and off automatically
depending on the brightness of the environment. In a dim condition, the Display Backlight turns on
automatically while in a bright condition, the Display Backlight turns off automatically.
General Specifications
Maximum voltage between any Terminals and
Grounding
Fused Protection for mA Input Terminal
Fused Protection for 20A Input Terminal
Range
Maximum Display
All manuals and user guides at all-guides.com
(figure 9)
DC 1000V or AC750V.
0.5A, 250V fast type,
Ø5x20mm.
Un-fused
Manual ranging
Display:19999
31