HOMCOM 820-291V80 Instructions De Montage page 26

EN
-Using the timer
This function (3) lets you choose how long you would like the unit to run. The timer
can be used for the flames and heater. If the heater is on when the timer is set, then
the timer will control the heater. If the flames are on when the timer is set, then the
timer will control the flames. If both are on when setting the timer, it will control
both. Pressing the button in sequence will set time you want. There is no clock
function for tuning the heater or flames on/off at a specific time.
-Using the heater control
The heater button (4) turns the heater on or off. There is no speed setting. If you put
the heater on standby, it will remember the previous settings. When turned back on,
it will resume with the same settings.
-When the heating function turns on, hold the heater button (4) for five seconds to
adjust the temperature – the LED will be red. When adjusting, the display (1)
flashes.
There are 22 levels for the Fahrenheit temperature.
Once set, the display (1) flashes five times.
If idle for 10 seconds, the display will turn off.
-When the heater is on, gently hold the main power button for five seconds to
convert the temperature. The red LED flashes five times, then changes to green.
When converting, the display (1) flashes. Hold the heater button (4) for five seconds
to adjust the temperature. There are 12 levels for the Celsius temperature.
Once set, the display (1) flashes five times. If idle for 10 seconds, the display turns
off.
Repeat the same process to convert from Celsius to Fahrenheit.
25