OVE SIERRA 60 Mode D'emploi page 9

1. Ensure the base and walls are leveled. Place the metal track (B) approximately 30mm (1-1/4in) from the
edge of the base to the center of the metal track. Ensure the metal track (B) is leveled, then mark the holes
clearly on the wall.
2. Remove track and drill pilot holes in the marked locations with a Φ8mm (5/16in) drill bit.
3. Insert the wall anchors (AA) using a rubber mallet until the wall anchors are flush with the wall.
4. Replace and secure the metal track (B) with screws (BB). Do not overtighten.
Helpful Hint
Make sure there
is a support stud
located behind the
drywall, behind the
tracks!
WALL TRACK INSTALLATION
Helpful Hint
Do not overtighten!
This may crack the
acrylic or tile walls.
9
1
B
2
Φ 8mm
5/16in
3
AA
4
BB