OVE SIERRA 60 Mode D'emploi page 10

1-2. Insert the fixed panel's bottom seal strip (N) at the base of the fixed glass panel (C). Cut the surplus part with a
cutter to size, about 40mm from the panel's edge.
3. Place the sliding door guide (Q) on the base.
4. Mark the positions of holes of the sliding door guide (Q) with a pencil, and drill pilot holes with a ø4mm (3/16in) drill
bit.
5. Fix the sliding door guide (Q) with the screw (CC). Ensure the plastic gasket in the guide is in place as it protects
the fixed glass panel.
6-7. Place the fixed glass panel (C) into the wall track (B) and the sliding door guide (Q).
Note: The wall track (B) allows you to adjust the position of the fixed glass panel (C). Adjusting the depth and/
or giving the fixed glass panel a slight angle allows for precise alignment with the door.
8. Drill the fixed panel (C) with Φ 3mm (1/8in) in 3 places.
9. Secure the wall track (B) using screws (DD), fittings (FF) and caps (EE).
FIXED PANEL INSTALLATION
Helpful Hint
Add a drop of
silicone in the
holes before
inserting the
screws
7
C
N
1
C N
N
3
Q
703mm
5
CC
8
Φ3mm
1/8in
Q
10
2
C
40mm
N
4
Φ4mm
3/16in
6
B
Q
9
DD
FF
C
EE