Output Log (Continuous Output); Kern Communications Protocol (Kern Interface Protocol) - KERN KIB-TM Notice D'utilisation Et D'installation

10.3 Output log (continuous output)

• Weighing
HEADER1: ST=STABLE， US=UNSTABLE
HEADER2: NT=NET， GS=GROSS

10.4 KERN Communications Protocol (KERN Interface Protocol)

KCP (KERN communication protocol) contains the commands that are used to
control the KERN balances via the interface.
• Finish commands with CR/LF character.
• Consult the KCP manual for more information, available on
our KERN website (www.kern-sohn.com).
The following commands are supported:
@
I0
I1
I2
I3
I4
˽ ˽
I4 A "xxxxxxxx"
I5
S
SI
SIR
Z
ZI
D
˽ ˽
D " "
DW
46
Cancel
List all implemented KCP commands
Query KCP level and KCP versions
Query device information (type, capacity)
Query device software version
Query serial number
Set serial number (default value is K123456)
Query SW-Identification number
Send stable weight value
Send weight value immediately
Send weight value immediately and repeat
Zero
Zero immediately
Display: Write text to display
Clear Display (after D-Command)
Display: Show weight
KIB-TM-BA_IA-e-1811