Publicité
Les langues disponibles
Les langues disponibles
3/8"
(10 mm)
7. Install the Wall Jambs
Position the second wall jamb at the mark 3/8" (10 mm) from the front ledge of the shower base.
Plumb the wall jamb using a level.
Temporarily secure the wall jamb with masking tape.
Make a pencil mark at each of the four slot locations in the wall jamb.
Remove the masking tape, then move the wall jamb to a safe area.
IMPORTANT! The supplied 6 mm drill bit is not suitable for drilling through tile. For tile installations,
use a 6 mm tile bit.
Slowly drill a 6 mm hole at each of the four marked hole locations, using the provided 6 mm drill
bit for non-tiled walls.
IMPORTANT! The provided wall anchors may not be appropriate for all wall material. Use another wall
anchor when needed.
Insert an anchor in each hole. Make sure the anchors are flush with the finished wall.
Secure the wall jamb to the wall using the four #8 x 1-1/2" screws.
1280799-2-B
All manuals and user guides at all-guides.com
10
6 mm
Kohler Co.
Publicité
