Techno Line WS 6448 Mode D'emploi page 6

date.
Press "MODE" to confirm your setting. Now use "▲" and "▼"buttons to set month/day or day/month.
Press "MODE" to confirm your setting, the language selection for the Weekday displays starts to flash. Now use "▲" and
"▼"buttons to select a language. There are 7 languages of Weekday: English, German ,Italian, French, Spanish, Dutch
and Danish
Press "MODE" to confirm your setting, the Time zones start to flash, Now use" ▲" and "▼" buttons to set a correct time
zone (-12 to +12). (Germany 0 / UK -1)
Press "MODE" to confirm your setting, the 12/24 hour mode display starts to flash. Now use "▲" and "▼ "buttons to set
The correct 12/24 hour mode.
Press "MODE" to confirm your setting, the Hour display starts to flash. Now use "▲" and "▼"buttons to set the correct
hour.
Press "MODE" to confirm your setting, the Minute displays starts to flash. Now use "▲" and "▼"buttons to set the correct
minute.
Press "MODE" to confirm your setting and to end the setting procedures, enter the clock mode.
Note:
After 7 seconds without pressing any button, the clock switches automatically from set mode to normal time mode.
Setting the daily alarms:
Press and hold down the ALARM button for 2 seconds until the Hour display of the alarm time starts to flash. Use the "▲"
and "▼"buttons to set the required hour. Press ALARM button to confirm your setting
The minute display of the alarm time starts to flash. Use the "▲" and "▼"buttons to set the required minute.
ALARM button to confirm your setting and to end the setting procedure.
To activate or deactivate the daily alarms, press the "ALARM" button once. The alarm is activated when the bell symbol is
displayed.
Note:
After 7 seconds without pressing any button the clock switches automatically from setting mode to normal clock mode.
The alarm will sound for 1 minute if you do not deactivate it by pressing any button. In this case the alarm will be
repeated automatically after 24 hours.
Rising alarm sound (crescendo, duration: 1 minutes) changes the volume 4 times whilst the alarm signal is heard.
Automatic SNOOZE function:
To activate the automatic snooze function: While the alarm is sounding, press the "SNOOZE/LIGHT" button to activate
the snooze function. When the snooze function is activated, the "Zz" symbol appears in the display.
The alarm will sound again 5 minutes later.
°C/°F temperature display:
The temperature is displayed either in °C or °F. Press the"▼"button to switch between °C or °F display.
Connection to outdoor sensor:
Press and hold down the "▼" button for 2 seconds to search for outdoor sensors (to erase the current data inside the clock).
Backlight:
Press the SNOOZE/LIGHT button to activate the display lighting for 5 seconds, if the indoor station is battery powered.
Weather forecast
The weather station uses the air pressure data for weather forecast. To forecast the weather, the station has 4
icons:
sunny light cloudy cloudy rainy
Hereby, Technotrade declares that this product WS 6448 is in compliance with the essential requirements and other relevant provisions
of Directive 2014/53/EU and ROHS 2011/65/EC. The original EU declaration of conformity may be found at:
www.technoline.de/doc/4029665064482
Technical data:
Radio controlled Clock via DCF frequency
Manual time setting
Continuous calendar up to year 2099
Date and weekday display
EN 2