Texas Equipment RMX 500 Manuel D'utilisation page 63

Importantt: Avoid that there is more than 2 meters of coiled wiring nearby the charging
station, as this may interfere with the signal. Initially, it is recommended to have about 1-2
m extra cable in excess behind the charging station, which is moved slightly away from the
charging station (obliquely backward, away from the cutting area), so that there is extra
wire to pull from, if you later need to repair the boundary wire (in case of breakage) or if
minor adjustments need to be made to the placement of the wire, which may require extra
length.
Test whether the placement of the excess wire interferes with the robot (does it return to
the charging station without problems?). If problem, then move the location of the excess
wire.
When you are sure that the robot runs without problems and the location of the boundary
wire is perfect, you can reduce the excess wire length to about 20-30 cm.
Connecting sleeve when using or extending cable
In case of breakage of the boandary wire that needs to be repaired - or when extending
the cable - it is important that a waterproof connector sleeve (silicone sleeve) is used.
De-isolate approximately 7-10 mm of the wire before inserting it into the silicone sleeve
(insulated wire must not be exposed outside the junction sleeve). Then press the blue
piece down, which seals the silicone sleeve. A bit of silicone will come out of the assembly
sleeve. The sleeves should be put down into the lawn, so that the blades cannot hit it.
Silicone sleeves are not included. If such are needed, a set can be purchased at
www.texas.dk. See section 24 "Accessories".
63