Texas Equipment RMX 500 Manuel D'utilisation page 53

Secure the charging station with the 6 supplied screws/pegs.
Make sure the "OUT" area points out towards the edge of the lawn
Once you have found the correct location and the charging station is set up, do NOT
connect the power yet. First, the boundary wire must be laid out and connected to the
charging station. After that, the power can be connected.
TIP
The charging station and the robot mower can stand under the open sky. But it is
recommended to build a roof / garage for the charging station, as it will protect the robot
from the weather and extend its lifetime. You can also buy an original garage roof, which
fits on the charging station. See more info in section 24 "Accessories".
53