LENCO DF-241 Mode D'emploi page 6

Installing the Software / Hardware
IMPORTANT: You must install the software to your computer before
connecting the device to your computer for the first time.
1. Insert the CD-ROM and run the file Photo Viewer SETUP;
follow the onscreen instructions.
2. The application Photo Viewer will be installed on your computerand a
shortcut to the application will appear on your desktop.
DO NOT LAUNCH THE SOFTWARE YET.
3. After the software is installed, connect the device to the computer with
the USB cable supplied. The hardware drivers will be installed
automatically. Follow the on-screen instructions and accept the
installation screens that appear.
4. After hardware installation is complete, launch the PhotoViewer
application from the shortcut on your PC desktop.
NOTE: If you are unable to launch the software or connect to your device,
go to the Troubleshooting of this manual for more information.
The internal battery of the device may be charged using the USB cable
when connected to a powered USB port(such as USB port on your
computer) or hub. At full charge, the device can provide up to 3 hours
of run time.
All manuals and user guides at all-guides.com
Charging the Battery
5