Jura ENA Micro 9 One Touch Mode D'emploi page 16

All manuals and user guides at all-guides.com
2 Preparation
Preparation stops automatically.
READY
Permanently setting the amount of water
for the cup size
It is easy to make permanent settings for the
amount of water for all specialty coffees and hot
water according to the cup size. Adjust the amount
once as shown in the following example. Every
time you prepare a drink in the future, this amount
of water will be dispensed.
Example: Permanently adjust the amount of
water for one coffee to the cup size.
Precondition:
is displayed. Milk is
READY
connected to the dual spout.
T Place a cup under the dual spout.
/ T Press and hold the Cappuccino button.
CAPPUCCINO
/ T Continue to hold the Cappuccino button
down until
ENOUGH MILK ?
/ T Release the Cappuccino button.
The milk foam is prepared.
T Press any button as soon as there is
sufficient milk foam in the cup.
OK
ENOUGH COFFEE ?
into the cup.
T Press any button as soon as there is
sufficient coffee in the cup.
,
OK CAPPUCCINO
one cappuccino are permanently stored.
READY
E You can alter this setting at any time by
repeating the above procedure.
Ground coffee
You can choose to use a second coffee variety, for
example decaffeinated coffee, with the powder
chute for ground coffee.
E Never add more than one level measuring
spoon of ground coffee.
16
The preparation of coffee, espresso, cappuccino
and latte macchiato with ground coffee follows
this model.
Example: Prepare a cup of coffee using ground
coffee.
Precondition:
appears.
, the coffee flows
, the set amounts for
> T Press the Coffee button to start preparation.
E Use ground coffee which is not ground too
finely. Very fine coffee can block up the
system so that the coffee only comes out in
drips.
E If you did not fill the machine with a
sufficient amount of ground coffee,
is displayed and the
ENOUGH POWDER
ENA stops the operation.
E The desired specialty coffee must be
prepared within approximately one minute
after filling with the ground coffee.
Otherwise the ENA stops the operation and
is once more ready for use.
is displayed.
READY
T Place a cup under the dual spout.
T Open the powder chute for ground coffee.
FILL POWDER
T Place the filler funnel for ground coffee on
the powder chute.
T Place one level measuring spoon of ground
coffee into the filler funnel.
T Close the powder chute for ground coffee.
SELECT BUTTON
, the preset amount of water
COFFEE
flows into the cup.
Preparation stops automatically.
READY
NOT