jbc ADVANCED Serie Mode D'emploi page 6

- Fit the extractor and press the sucker down until
it sticks onto the component.
- Use the pedal or the HEAT button to start the
self-contained hot-air pump, directing it with a
circular movement at the component terminals
and taking care to distribute the heat evenly.
- When the soldering flux turns liquid the extractor
will automatically lift the component.
All manuals and user guides at all-guides.com
There are different models of protectors and
extractors as accessories.
The measurements of all the extractors and
protectors are given on page 128 of instructions
manual.
C) Tripod:
For small components for which an extractor
cannot be used, we recommend use of tripod 20
Ref. 0932050, as shown in the figure.
Use the tripod 40 Ref. 0932250 for larger integrated
circuits.
SOLDERING PROCEDURE
1 After desoldering the component, any solder
5
left on the printed circuit should be removed
with our desoldering iron DR 5600 ref. 5600000.
ENGLISH