Pioneer SUPER TUNER III D FH-P4200MP Mode D'emploi page 40

Section
10 Digital Signal Processor
1 Press DSP to select the graphic equali-
zer.
Press DSP until PWRFL appears in the display.
# If the graphic equalizer has been previously
set to an equalizer curve other than PWRFL then
the title of that previously selected equalizer
curve will be displayed instead of PWRFL.
2 Press c or d to select an equalizer
curve.
Each press of c or d selects equalizer curves
in the following order:
PWRFLNTRLVOCALCTM1CTM2
FLATS-Bas
Adjusting equalizer curves
The factory supplied equalizer curves, with the
exception of FLAT, can be adjusted to a fine
degree (nuance control).
1 Recall an equalizer curve.
See Recalling equalizer curves on the previous
page.
2 Press a or b to adjust the equalizer
curve.
Each press of a or b increases or decreases
the equalizer curve respectively.
+6  5 (or 6) is displayed as the equalizer
curve is increased or decreased.
# The actual range of the adjustments are differ-
ent depending on which equalizer curve is se-
lected.
# The equalizer curve with all frequencies set to
0 cannot be adjusted.
Adjusting 9-band graphic equalizer
For CTM1 and CTM2 equalizer curves, you
can adjust the level of each band.
! A separate CTM1 curve can be created for
each source. (The built-in CD player and
the multi-CD player are set to the same
40
En
All manuals and user guides at all-guides.com
equalizer adjustment setting automati-
cally.) If you make adjustments when a
curve other than CTM2 is selected, the
equalizer curve settings will be memorized
in CTM1.
! A CTM2 curve can be created common to
all sources. If you make adjustments when
the CTM2 curve is selected, the CTM2
curve will be updated.
1 Recall the equalizer curve you want to
adjust.
See Recalling equalizer curves on the previous
page.
2 Press DSP to select 9-band graphic
equalizer.
Press DSP until 50 : +1 appears in the display.
# If 9-band graphic equalizer has been pre-
viously adjusted, the frequency of that previously
selected will be displayed instead of 50 : +1.
3 Press c or d to select the equalizer
band to adjust.
Each press of c or d selects equalizer bands
in the following order:
501002004008001.6 k3.15 k
6.3 k12.5 k (Hz)
4 Press a or b to adjust the level of the
equalizer band.
Each press of a or b increases or decreases
the level of the equalization band.
+6  6 is displayed as the level is increased
or decreased.
# You can then select another band and adjust
the level.