Publicité
Les langues disponibles
Les langues disponibles
T66 Owner's Manual
Connecting the LFE Input
*Using the LFE Input is always in addition to connecting speaker cables, it is never a replacement for connecting
speaker cables.
With surround sound playback you also have the option to use the line-level LFE input in addition to speaker ca-
bles. Many AV receivers and processors have two LFE outputs, one for each T66. However, for receivers or proces-
sors with only one LFE output, simply use a "Y" connector (available from your dealer) out of the Sub/LFE output
to feed two line-level cables from the Y connector to each T66.
Now set the receiver or processor's bass management system for "Large" left and right front speakers and also
select "Yes" for subwoofer. This will send only the .1 LFE signal via the line-level cables to the T66's LFE input.
This configuration allows the AV receiver/processor to set the LFE channel volume level independently for movie
playback (or any source with a ".1" channel). PLEASE NOTE: Some AV receivers/processors have a setting
called "Double Bass", "Super Bass" or "Bass+." This option sends both LFE and bass above a specified crossover
frequency to the LFE channel. We recommend avoiding this configuration as it will likely cause the speakers
to sound bloated and bass heavy.
10
GoldenEar T66 Manual
T66 Tower Manual_ENG_FR_05_25_23_DRAFT.indd 10
T66 Tower Manual_ENG_FR_05_25_23_DRAFT.indd 10
AV RECEIVER / PROCESSOR
Min
Max
Subwoofer
Level
Remove Jumpers to Bi-Wire
For Single Speaker Cable:
• Keep Jumpers Inserted
• Connect Cable to Treble
LFE
Input
Auto
On/Off
L
AC 120V 60Hz
1200 WATTS
GoldenEar Irvine, CA 92614 USA
Min
Max
Subwoofer
Level
Remove Jumpers to Bi-Wire
For Single Speaker Cable:
• Keep Jumpers Inserted
• Connect Cable to Treble
LFE
Input
Auto
On/Off
L
AC 120V 60Hz
1200 WATTS
GoldenEar Irvine, CA 92614 USA
6/1/23 6:12 PM
6/1/23 6:12 PM
Publicité
