Haier AD122ALEAA Manuel D'instructions, D'installation, D'utilisation Et D'entretien page 16

Operation
HEALTH
C
CHECK
2
4
5
3
6
SET RECOVERY
1,7
(1) Start up operation:
Press the ON/OFF button. The system will start up and the
display will be on LCD.
(2) Select operation mode:
Press the MODE button.
the [MODE] display section changes as
[FAN ONLY] [COOL]
[FAN ONLY].
Select operation mode ([COOL],[DRY],[HEAT],or [AUTO]).
(3) Set temperature:
Press the TEMP + or - button. Each press, setting
temperature will increase or decrease by 1 C ( F).
TEMP.] appears on the display.
(4) Select fan speed:
Press the FAN button.
display section changes as
[AUTO] [HIGH]
Select proper fan speed.
(5) Select SWING function:
Press the SWING button once, [SWING] will display and
swing function is valid. Press again, [SWING] will disappear
and swing function is invalid.
(6) Set HEALTH operation:
Press the HEALTH button to set the indoor health function.
Press it once, [HEALTH] will display in the display section,
and indoor health function is valid. Press it again, [HEALTH]
will disappear, and the health function is invalid. This function
is valid only for the unit with health function.
(7) Power off:
Press the ON/OFF button. Indoor unit will be powered off,
and there are only the time and the ambient temperature
in the screen.
10
Auto, Cool, Heat, and Dry
Each press, operation mode in
follows:
[DRY] [HEAT] [AUTO]
Each press, fan speed in the [FAN]
follows:
[MED] [LOW] [AUTO].
[SET