Russka Rollator Aluminium Mode D'emploi page 9

Back rest
You can insert the back rest into the sockets in the tube on the front of the rollator. You can fix it with the enclosed clips
(pic. 5–8).
The back rest is for support when sitting and facilitates comfortable sitting posture during a rest. Always lean slowly and
evenly against it. Do not hang any coats or bags over it.
General care and cleaning
Rollator
The rollator can be cleaned with lukewarm water, neutral commercial and household cleaning agents and a soft cloth to
remove dirt, then rinsed and dried. No water must get into the pipes. After cleaning or after rain, dry the walker thorough­
ly with a dry, clean cloth. Also clean the brake pads and springs regularly. Do not use abrasive, corrosive or bleaching
cleaning agents. Do not use metal brushes or other sharp­edged cleaning aids for cleaning. Further cleaning instructions
for reuse and before changing patients can be found under the Hygiene Plan.
Do not use the rollator in temperatures below –35 °C or above +60 °C.
Re-use
The product can be re­used. It must be cleaned and disinfected according to instructions. It must be inspected by special­
ist shops for any faults and then authorised before it can be used again. Please order our hygiene and maintenance guide­
lines. Send your rollator for regular checks to your dealer. He will be able to detect any wear and tear and replace parts, if
necessary. If you find the brake action to be faulty in any way, please contact your dealer immediately.
Please find below a maintenance table and hygiene plan for the regular care and maintenance of this device:
Maintenance Table
When
Before every re­use
What
Check general condition
Visually inspect all frame parts including welded joints for
deformation, damage, wear or corrosion
Check hand grips visually and by attempting to turn them If you find that the hand grips are damaged or no longer
Check the tyre tread and ball bearings
Check the folding lock
Check the connecting elements for tightness
Check the braking system is working satisfactorily
Apply the operating brake until it reaches the stopping
point. The wheels must not be able to turn now when
pushed hard.
Apply the parking brake by pressing the brake levers down
until it engages.
The wheels must not be able to turn now when pushed hard.
Send your rollator for regular checks to your dealer. He will be able to detect any wear and tear and replace parts, if neces­
sary. If you find the brake action to be faulty in any way, please contact your dealer immediately.
Caution
If you find any defects, replace the affected parts of the
device.
firmly connected to the frame, they must be replaced.
If you find that the wheels are worn or cracked, they must
be replaced.
If the folding mechanism no longer works properly, it must
be repaired or replaced.
If you find that screws, nuts, rivets, etc. are loose or missing
they must be tightened, fitted or replaced.
If the brakes are defective, the brake slack, brake cables,
brake shoes and wheels must be checked and the defective
part of the device must be replaced if necessary.
60°C
–35°C
9