Publicité
TROUBLESHOOTING
PROBLEM
Scraper bar does not clean
hard surface.
Unit fails to propel itself.
Unit fails to discharge
snow.
32
All manuals and user guides at all-guides.com
LOOK FOR
Skid shoes improperly adjusted. Raise or lower skid shoes.
Drive belt loose or damaged.
Incorrect adjustment of traction
drive cable.
Worn or damaged friction disc.
Auger drive belt loose or
damaged.
Auger control cable not adjusted
correctly.
Broken shear pin.
Discharge chute clogged.
Foreign object lodged in auger.
Replace drive belt. See authorized dealer.
Adjust traction control cable. Refer to "Check and Adjust the Cables" in the
MAINTENANCE section of this manual.
Replace friction disc. See authorized dealer.
Replace or adjust auger drive belt. Refer to "Belt Adjustment" in the
MAINTENANCE section of this manual, or see authorized dealer.
Adjust auger control cable. Refer to "Check and Adjust the Cables" in the
MAINTENANCE section of this manual.
Replace shear pin. Refer to "Auger Shear Pin Replacement" in the MAINTENANCE
section of this manual.
Stop engine immediately. Always use the clean-out tool to clear a clogged
discharge chute, not your hands. Clean discharge chute and inside of auger
housing. Refer to WARNINGS in OPERATOR SAFETY section.
Stop engine immediately. Always use the clean-out tool to clear a clogged chute,
not your hands. Remove object from auger. Refer to WARNINGS in OPERATOR
SAFETY section.
REMEDY
www.sears.ca/craftsman
Publicité
