Publicité
Les langues disponibles
Les langues disponibles
T r o u b l e s h o o t i n g
F a u l t
The motor does not start after
pressing the ON/OFF switch
or stops during operation.
The automatic circuit breaker
in the electrical distribution
board trips.
The magnetic clamp does not
function.
Tools wear excessively/are
damaged.
The lubrication system does
not function.
NOTE
►
If you cannot resolve the problem with the steps described above, please contact
customer service.
2 0
All manuals and user guides at all-guides.com
T r o u b l e s h o o t i n g
P o s s i b l e c a u s e
Plug not inserted into socket.
Automatic circuit breaker
tripped.
Magnetic clamp not switched
on.
Too many appliances
connected to the same power
circuit.
The machine is defective.
Magnet not switched on.
The surface is not magnetic.
No lubrication or not
sufficiently greased.
No lubricant available.
Lubricant tap closed.
Connecting nipple (4)
clogged.
R e m e d y
Insert plug.
Switch on on automatic circuit
breaker
Switch on the magnetic
clamp.
Reduce the number of
appliances on the power
circuit.
Contact customer service.
Switch on magnet.
Use a suitable base.
Supply lubrication
(e.g.:use pump bottle
for cutting oil/drilling
emulsion (C)).
Top up the lubricant.
Open the lubricant tap.
Clean container and
connecting nipple (4).
M A B 1 5 0
Publicité
