Publicité
Les langues disponibles
Les langues disponibles
C l e a n i n g
El i m i n a t i n g b l o c k a g e s
W A R NING
D a n g e r o f c u t i n j u r i e s f r o m
t o o l p a r t s o r s w a r f .
►
Put protective gloves on before
starting work.
B l o c k a g e s c a u s e d b y a b r o k e n t o o l :
Switch off the machine with the red
‹
button (12) of the motor switch.
Hold the handle tightly (5) to stop the
‹
machine from slipping.
Switch off the magnetic clamp with the
‹
switch (10). The indicator lamp in the
switch (10) extinguishes.
Disconnect the voltage supply (pull out
‹
the mains plug).
Use the hand lever (6) to move the
‹
machine slide to the upper position.
Replace defective tool. Remove swarf.
‹
O t h e r b l o c k a g e s :
Switch off the machine with the red
‹
button (12) of the motor switch. Leave
the magnetic clamp switched on.
Use the hand lever (6) to move the
‹
machine slide to the upper position.
Remove swarf and check tool.
‹
1 8
All manuals and user guides at all-guides.com
b r o k e n
C l e a n i n g
W A R NING
►
Switch off the machine and
disconnect the voltage supply before
performing maintenance or cleaning
(pull out the mains plug).
►
When using compressed air for
cleaning, wear protective goggles and
gloves and protect other persons in
the working area.
CAUTION
►
Never immerse the machine in water
or other liquids.
A f t e r e v e r y u s e
Remove the inserted tool.
‹
Remove swarf and coolant residues.
‹
Clean the tool and the tool holder on
‹
the machine.
Clean the guide of the machine slide.
‹
Put the machine and accessories into
‹
the transport case.
M A B 1 5 0
Publicité
