Publicité
Les langues disponibles
Les langues disponibles
Sw i t c h i n g t h e m a c h i n e O N/ O F F
Sw i t c h i n g o n t h e m a c h i n e
Switch on the machine with the green
‹
button (11) of the motor switch.
NOTE
►
The machine can only be switched on
when the magnetic clamp has been
switched on.
►
Allow a severely overheated machine
to run on at idle speed for approx.
2 minutes.
►
The machine switches off
automatically in the event of a power
failure or if the magnetic clamp is
switched off.
Sw i t c h i n g o f f t h e m a c h i n e
Switch off the machine with the red
‹
button (12) of the motor switch.
M A B 1 5 0
All manuals and user guides at all-guides.com
D r i l l i n g w i t h c o r e d r i l l s
When drilling with core drills, proceed as
follows:
D r i l l i n g w i t h t h e m a c h i n e
Insert the ejector pin (A) into the core
‹
drill.
Insert the core drill with the ejector pin
‹
as described in the section " In s e r t i n g
t h e t o o l " .
Place the machine at the working
‹
location, align it and switch on the
magnetic clamps.
Switch the machine on.
‹
Direct the core drill to the material with
‹
the hand lever (6).
NOTE
Observe the following instructions when
drilling with core drills:
►
Drilling with core drills does not
require great force. The drilling
process is not accelerated by higher
pressure. The drill wears faster and
the machine can be overloaded.
►
Use the pump bottle for cutting
oil/drilling emulsion (C) with CS
Unitec high-performance cutting oil
supplied for the machine.
►
When working overhead, use the
ZHS 400 high-performance grease
spray. Spray the drill on the inside
and outside before drilling. In the
case of larger drill depths, repeat this
procedure.
►
Make sure that swarf is removed
regularly. With larger drilling depths,
break up the swarf.
U s e
1 7
Publicité
