Getting Started - Loc8tor Tabcat Mode D'emploi

GETTING STARTED

Your Tabcat could not be easier to set up or use. Follow these steps and you'll
be able to start tracking your tagged cat or kitten in no time at all.
1. ACTIVATE HANDSET BATTERY
Pull out the strip on the back of the Handset to activate battery. It will beep and all
the lights will flash – It is now ON.*
* After approx. 45 seconds left idle your Handset will turn itself off.
2. REGISTER A TAG
• To activate Tag and register pull out white strip and then press Tag firmly shut to ensure closed.
• Place Tag you wish to register next to the Handset making sure all other Tags have been moved away.
• Make sure the Handset is switched on (red status light will flash when ON).
• Select one of the buttons on the front of the Handset to assign the Tag to.
Hold the button down for 3 seconds. The Handset will beep. Release button.
• Tabcat will now start registration and status light will flash rapidly. Tag will complete registration process.
• Once registered the Tag and Handset will beep and flash once.
• Repeat process for up to 4 Tags, assigning each Tag to a different button. (Tags can only be registered to
one button at a time.) Each of the four Tags when being located will beep differently to help identification.
3. ATTACH TAG TO COLLAR
Insert the Tag in to the splashproof case by pushing it through the hole
in the back. Then attach directly onto your pets collar by threading
collar through the two holes on the back of the case.
Please note that we recommend using the silicone case provided in the pack to
attach the Tag to your cat's collar. Failure to use the case can result in the Tag
becoming damaged. Additional protective cases can be purchased via our website.
www.mytabcat.com
Thread collar
through holes
5