Disassemble The Freezer Drawer - Samsung Rf4287Ha Mode D'emploi

DISASSEMBLE THE FLEX DOOR
1. Take out the Flex
Zone ( 1 ) by lifting it
up.
2. Take off the cover
( 2 ) w/harness with a
fl at-blade screwdriver
(-).
3. Press the locking tab and separate the Wire
Connector.
When reassembling it, be sure to connect the
wire harness.
CAUTION
If it is not connected, the Flex Room does not
work.
4. Remove 2 hex head
bolts from sides with
a socket wrench
(10mm).
5. Lift up the Flex door from
the rails.
Putting too much food into the freezer
drawers can prevent the freezer from closing
CAUTION
completely and
can cause frost
build-up.
08_ setting up
DA68-01922B.indb 08 DA68-01922B.indb 08
ASSEMBLE THE FLEX DOOR
To reattach the fl ex doors, assemble parts in reverse
order.
1
CAUTION
DISASSEMBLE THE FREEZER
2
DRAWER
1. Take out the upper
2. Remove the tilting pocket ( 1 ) by pulling both
3. Take out the lower
4. Remove 4 hex head bolts
5. Lift up the freezer door from
Be sure to connect the Flex Door Wire
Connector.
If it is not connected, the Flex Room does not
work.
drawer by lifting it up.
support guards ( 2 ) aside. And take out both
support guards by pulling them aside.
basket ( 3 ) by lifting
the basket up from
the rail system.
from both sides with a
socket wrench (10mm).
the rails.
1
2
3
2013.3.6 8:40:48 AM 2013.3.6 8:40:48 AM