Publicité
Les langues disponibles
Les langues disponibles
en-US
Hold the fine dust filter over a
garbage can.
Carefully knock the fine dust filter
with the rubberized lower edge.
Turn the fine dust filter slightly while
you do this to free the dirt from all of
the crevices.
Risk of damage caused by incor-
rect cleaning.
The pre-filter can become damaged
and be less effective as a result.
Do not clean the pre-filter with water.
Do not use pointed or sharp-edged
objects to clean the filter.
Clean the pre-filter with the dusting
brush supplied or with a dry cloth.
After cleaning the fine dust filter and
pre-filter, reinsert the former into the
latter by pressing the round cap on
top of the fine dust filter down as far
as it will go.
To continue achieving the best possi-
ble cleaning results, replace the fine
dust filter (HX FSF-2) with a new one
after approx. 3 years.
Reinsert the pre-filter in the dust con-
tainer (Fig. 41).
To do this, line up the guides (arrows)
and turn the pre-filter back to its orig-
inal position (Fig. 42).
Close the dust container flap, making
sure it clicks into place.
Replace the dust container on the
PowerUnit connector.
Cleaning the dust container
Clean the dust container as required.
182
Remove the dust container.
Empty the dust container over a
garbage can and lift the pre-filter up-
ward to remove it (Fig. 39).
Clean the dust container using water
and mild detergent.
Dry the dust container carefully.
Reinsert the pre-filter in the dust con-
tainer and turn the pre-filter back to
its original position (Figs. 41 + 42).
Replace the dust container on the
PowerUnit connector.
Cleaning the Electrobrush/handheld
brush (depending on model) (Fig. 43)
Disconnect the Electrobrush/hand-
held brush from the vacuum cleaner
(Fig. 10).
Place the Electrobrush/handheld
brush upside down on a level, clean
surface.
Use a pair of scissors to cut any
threads or hairs that have wound
themselves around the roller brush.
To guide the scissors, move along the
guide track on the roller brush.
Then run the vacuum cleaner to vac-
uum up the cut threads and hairs.
If the small running wheels are very
heavily soiled or blocked, you can re-
move them for easier cleaning (not
necessary in the case of the handheld
brush). To remove them, use a flat-
head screwdriver.
Removing the roller brush from the
Electrobrush (Fig. 44)
(Not possible with the handheld brush)
Publicité
