cecotec CONGA 7290 ETERNAL HOME X-TREME Manuel D'instructions page 55

- If your house is very large and the robot vacuum cleaner runs out of battery, it will return
to the self-emptying base, save both complete and incomplete maps, and, once charged, it
will resume cleaning where it left off until the entire surface has been mapped. The robot
vacuum cleaner is constantly mapping, so it adapts in an individualised and personalised
way to the particularities of each house while constantly improving its map.
Information on the self-emptying base.
- This self-emptying base features both a loading and an emptying function.
- The robot vacuum cleaner automatically returns to the self-emptying base to recharge
the battery.
- You can adjust the emptying frequency of your robot vacuum cleaner from the app. You
can also empty it on command by pressing the robot vacuum cleaner's Back Home button
or from the app.
- When the robot vacuum cleaner reaches the self-emptying base, it beeps to let you know
it's made contact with the base terminals. In case of programmed emptying, the robot
vacuum cleaner will beep one time when it starts emptying and one tine once it finishes.
- If the light indicator on the self-emptying base is red, it may indicate that the dirt-
disposal bag is missing or full. Correctly position or change the dirt-disposal bag. If the
light indicator does not change colour, you should check the dust channel to ensure there
are no obstructing objects. To do this, remove the transparent cover with the help of a
screwdriver as shown in Figure 9.
If the light indicator on the self-emptying base is red, it may indicate that the dirt-disposal bag
is not placed or is full. If so, place or replace it. If the error persists, rotate the self-emptying
base to check if there is an object obstructing the channel. In this case, remove the transparent
lid using a screwdriver as shown in figure 9 to remove the obstruction.
3. OPERATION
Robot vacuum cleaner's buttons
Automatic mode
- Press the Start/Pause button on the robot vacuum cleaner or select it in the app to make it
start cleaning automatically in Edge mode and then perform a cleaning cycle in an orderly
zigzag pattern while it also recognises which areas have been cleaned and which have not.
The robot will automatically plan the cleaning route as it is cleaning.
- If during this mode the robot is controlled manually, it will calculate the route again and
could go through previously cleaned areas. To ensure efficient cleaning, do not operate the
robot vacuum cleaner manually during automatic cleaning.
CONGA 7290 ETERNAL HOME X-TREME
ENGLISH
55