cecotec CONGA 7290 ETERNAL HOME X-TREME Manuel D'instructions page 54

ENGLISH
3. Hold down the Start/Pause button for 3 seconds.
4. When the light indicator turns on, place the robot vacuum cleaner on the self-emptying
base and make sure the charging terminals on the robot match those of the charging
base. If the light is flashing blue, it means the battery is not completely charged. To ensure
the maximum cleaning time, wait until the light turns into steady blue, as this will indicate
the battery is fully charged and the robot is ready to clean.
Warning
- Take the robot vacuum cleaner to the self-emptying base if the battery is low. The robot
vacuum cleaner may not turn on if the battery is very low.
- The robot vacuum cleaner will automatically turn on when placed on the self-emptying
base.
- The robot vacuum cleaner cannot be turned off during charging.
Installing the mixed tank. Fig. 8
- Open the tank silicone cover, fill the tank with water carefully so water does not come out.
Make sure the silicone clip is properly closed to avoid water from pilling. Never immerse
the tank in water or other liquids.
- Install the mop on the mop bracket.
- To install the tank on the robot vacuum cleaner, follow the direction shown in figure 8 and
manually press the tab and push it into the correct position. You will hear a click when it is
properly fixed.
- Install the mop bracket following the direction shown in figure 8.
Recommendations:
- It is not suggested to use the scrubbing function for the first-time use.
- Do not use the mopping function if the robot vacuum cleaner is not being supervised.
- To remove the mop bracket, press the release button and pull from it outwards.
- Uninstall the mop bracket when the robot vacuum cleaner is charging or when not in use.
- Add a few drops of cleaning agent to the water, if necessary, as long as it is non-corrosive.
- Using cleaning agents in excess might block water outlets.
- In order to achieve perfect scrubbing, it is suggested to moisten the mop before using it.
First use
- Once the robot vacuum cleaner and the self-emptying base are installed, follow these
steps before the first cleaning.
- First of all, fully charge the robot vacuum cleaner. It is suggested to allow the robot to
charge overnight. Once fully charged, it may carry out the first cleaning cycle and save
the first map. To do so, activate the Auto mode and select the Eco suction level. It is very
important to follow these instructions so that the robot vacuum cleaner recognises every
corner of your house and can carry out a complete mapping of it.
54
CONGA 7290 ETERNAL HOME X-TREME