Polaris 140 Mode D'emploi page 10

Troubleshooting
If the Polaris cleaner displays the following
actions, adjustments may be necessary to
restore performance. Refer to the exploded
parts diagram for part numbers indicated
in parentheses.
Action: Polaris 140/145 gets stuck on
steps or other pool obstacles.
Solution: 1. Using flow indicator (#24),
2. Reposition eyeball fittings on
3. Reposition deflector ring or
4. Rotate the steering skirt (#15)
5. Verify that hose is adjusted
6. Remove unnecessary pool
Action: Polaris 140/145 is sluggish,
running with less power than
normal.
Solution: 1. Using the flow indicator (#24),
2. Clean pool filter and
3. Turn cleaner upside down,
4. Check shoe (#17) and ball
5. Remove bypass intake to
All manuals and user guides at all-guides.com
verify proper water flow to
cleaner. Adjust to high end of
target range.
return lines so flow moves
hose and cleaner away
from obstacles.
add another deflector ring
(part #8-6052) if multiple
obstacles exist.
to opposite side of cleaner.
to the proper length and
hose weights (#23) are
positioned correctly.
hardware, or install a Ladder
Guard (part #G21).
verify proper flow to cleaner.
pump basket.
clear debris from ball valve
chamber and bypass intake.
valve seat (#11) for signs of
wear. Replace if necessary.
check bypass disk (#13) and
www.polarispool.com
o-ring (#2) for damage or
excessive wear. Replace
if necessary.
Action: Polaris 140/145 has stopped
operating.
Solution: 1. Using flow indicator (#24),
verify proper water flow to
cleaner.
2. Turn cleaner upside down,
clear debris from ball valve
chamber and bypass intake.
3. Check shoe (#17) and ball
valve seat (#11) for signs of
wear. Replace if necessary.
4. Remove bypass intake to
check bypass disk (#13) and
o-ring (#2) for damage or
excessive wear. Replace if
necessary.
Action: Polaris 140/145 appears to get
stuck repeatedly at the
water line.
Solution: 1. Using flow indicator (#24),
verify proper water flow to
cleaner. Adjust flow to the
lower end of target range.
2. Verify the flow regulator (#19)
is clear of debris.
3. Position hose weight (#23)
farther away from cleaner or
add additional hose weight.