Kohler K-8022 Guide D'installation page 6

Waterway
Ribs
Groove
Attach the Sprayhead
3. Complete the Installation
Attach the Sprayhead
With the ribs of the sprayhead facing up, attach the sprayhead to
the waterway.
Using a 3/16" hex wrench, secure the sprayhead to the waterway
with the two hex screws provided.
Verify the sprayhead moves freely upward and downward.
Place the nozzle membrane over the sprayhead.
Attach the Sprayface
Tilt the sprayhead downward so the ribs on the top of the
sprayhead are exposed.
Insert the grooves of the sprayface over the ribs of the sprayhead.
Press the sprayface down to cover the sprayhead, as illustrated.
Tilt the sprayhead upward to expose the setscrew holes on the
bottom of the sprayhead.
Using a 7/64" hex wrench, turn the setscrews counterclockwise
until they are flush with the edge of the sprayface frame.
IMPORTANT! The setscrews must be flush with the edge of the
sprayface frame. If the setscrews protrude outside of the sprayface
frame, product damage will occur.
1046519-2-B
All manuals and user guides at all-guides.com
Finished Wall
Sprayhead
Hex Screws
Nozzle
Membrane
Attach the Sprayface
6
Ribs
Sprayface
Setscrews
Kohler Co.