Teddington DTF950E Mode D'emploi page 6

gb
ConTRols
See page 4, fig. 4
on/oFF (1)
The unit is switched on and off by pressing the ON/OFF button
(1). When the unit is on, the fan runs in the set speed.
Humidity (2)
Press the HUMIDITY button (2) repeatedly to choose the desired level of relative
humidity in the area. The corresponding control lights (2) will indicate the selected
percentage. The yellow CNT control light (5) indicates that the unit is running
continuously, disregarding the relative humidity level in the area.
Ventilator speed (3)
Press the SPEED button (3) to select low or high speed.
The corresponding control light (3) will indicate this, Lo=low or Hi=high.
Digital display (4)
The digital display (4) will show the measured relative humidity in the area.
Compressor (6)
The COMP control light (6) will be on when the compressor is running.
An automatic time delay of five minutes before the compressor can (re-)start
working is a safeguard against damage.
ImpoRTAnT:
This dehumidifier should not be used in temperatures below 7 °C or above 35 °C.
Defrost Control
The dehumidifier is equipped with an automatic de-icing mode to defrost the
refrigeration coil during low temperature operation. The compressor is switched off
whilst the ventilator continues to run.
6