Getting Started - Kenwood KMM-112 Mode D'emploi

GETTING STARTED

1
Cancel the demonstration
When you turn on the power (or after you reset the unit), the
display shows: "CANCEL DEMO" "PRESS" "VOLUME KNOB"
1
Press the volume knob.
[YES] is selected for the initial setup.
2
Press the volume knob again.
"DEMO OFF" appears.
2
Set the clock
1 Press the volume knob to enter [FUNCTION].
2 Turn the volume knob to select [CLOCK], then press the knob.
3 Turn the volume knob to select [CLOCK ADJUST], then press
the knob.
4
Turn the volume knob to make the settings, then press the
knob.
Day Hour Minute
5
Turn the volume knob to select [CLOCK FORMAT], then press
the knob.
6
Turn the volume knob to select [12H] or [24H], then press the
knob.
7
Press and hold to exit.
To return to the previous setting item, press
While in clock display screen...
Press and hold to enter clock adjustment mode
directly.
4
Then, perform step to set the clock.
4
3
Set the initial settings
1
Press
2
Press the volume knob to enter [FUNCTION].
3
Turn the volume knob to make a selection (see the following table), then
press the knob.
4
Repeat step
5
Press and hold
To return to the previous setting item, press
AUDIO CONTROL
SWITCH PREOUT
SP SELECT
TUNER SETTING
PRESET TYPE
SYSTEM
KEY BEEP
SOURCE SELECT
BUILT-IN AUX
F/W UPDATE
UPDATE SYSTEM
.
F/W UP xx.xx
CLOCK
CLOCK DISPLAY
repeatedly to enter STANDBY.
3
until the desired item is selected or activated.
to exit.
REAR/ SUB-W: Selects whether rear speakers or a subwoofer are connected to
the line out terminals on the rear (through an external amplifier).
OFF/ 5/4/ 6 × 9/6/ OEM: Selects according to the speaker size (5 inches or
4 inches, 6×9 inches or 6 inches) or OEM speakers for optimum performance.
NORMAL: Memorizes one station for each preset button in each band (FM1/
FM2/ FM3/ AM). ; MIX: Memorizes one station for each preset button, regardless
of the selected band.
ON: Activates the keypress tone. ; OFF: Deactivates.
ON: Enables AUX in source selection. ; OFF: Disables. ( 8)
YES: Starts upgrading the firmware. ; NO: Cancels (upgrading is not activated).
For details on how to update the firmware, see: www.kenwood.com/cs/ce/
ON: The clock time is shown on the display even when the unit is turned off. ;
OFF: Cancels.
.
Default: XX