Attaching Blade - Ryobi CSB142LZ Manuel D'utilisation

WARNING:
If any parts are damaged or missing do not operate
this product until the parts are replaced. Use of this
product with damaged or missing parts could result in
serious personal injury.
WARNING:
Do not attempt to modify this product or create acces-
sories not recommended for use with this product. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.
WARNING:
Do not connect to power supply until assembly is
complete. Failure to comply could result in accidental
starting and possible serious personal injury.
WARNING:
A 7-1/4 in. blade is the maximum blade capacity of the
saw. Also, never use a blade that is too thick to allow
outer blade washer to engage with the flat on the spindle.
Larger blades will come in contact with the blade guards,
while thicker blades will prevent blade screw from se-
curing blade on spindle. Either of these situations could
result in a serious accident.
CAUTION:
To prevent damage to the spindle or spindle lock, always
allow motor to come to a complete stop before engaging
spindle lock.

ATTACHING BLADE

See Figures 2 - 4, page 18.
 Unplug the saw.
 Depress and hold spindle lock button.
 Remove blade screw by turning it counterclockwise with
the blade wrench, while keeping the spindle lock button
depressed.
 Remove spring washer and outer blade washer ("D"
washer).
 Wipe a drop of oil onto the inner flange bushing and outer
blade washer ("D" washer) where they contact blade.
ASSEMBLY
WARNING:
If inner flange bushing has been removed, replace it be-
fore placing blade on spindle. Failure to do so will prevent
blade from tightening properly and could result in serious
personal injury.
 Retract the lower blade guard into the upper blade guard
using the lower blade guard handle. Make sure the lower
guard spring works properly, allowing the guard to move
freely.
 Check to see that the saw teeth and arrow on the saw
blade and the arrow on the upper guard are pointing in
the same direction.
NOTE: The saw teeth point upward at the front of the saw
as shown.
 Fit the saw blade inside the lower blade guard and onto
the spindle.
 Replace "D" washer.
 Replace spring washer with cupped side against "D"
washer.
 Depress spindle lock button and replace blade screw.
 Tighten blade screw securely by turning it clockwise with
the blade wrench.
NOTE: Never use a blade that is too thick to allow the
"D" washer to engage with the flat on the spindle.
REMOVING BLADE
See Figures 2 - 4, page 18.
 Unplug the saw.
 Depress and hold spindle lock button.
 Remove blade screw by turning it counterclockwise with
the blade wrench, while keeping the spindle lock button
depressed.
 Remove spring washer and outer blade washer ("D"
washer).
 Lift lower blade guard.
 Remove blade.
INSTALLING EDGE GUIDE
See Figure 5, page 18.
Use edge guide when making long or wide rip cuts with
the saw.
 Unplug the saw.
 Place edge guide through holes in base as shown.
 Adjust edge guide to the width needed.
 Tighten edge guide knob securely.
10 - English