Publicité
Les langues disponibles
Les langues disponibles
Nylon cutting head
NOTICE:
The bump feed will not operate properly if the
•
Nylon cutting head is not rotating.
012404
The nylon cutting head is a single string trimmer head
provided with a bump & feed mechanism.
To cause the nylon cord to feed out, the cutting head
should be bumped against the ground while the tool is
running. As the nylon cord is feeding out it will
automatically be cut to the proper length by the cutter
on the guard.
NOTE:
If the nylon cord does not feed out while bumping
•
the head, rewind/replace the nylon cord by
following
the
"Installing or removing the Nylon cutting head" and
"Winding a new Nylon cord on the spool."
Do not bump the tool to the concrete or asphalt
•
surface. Bumping to this kind of objects may
cause the tool damage.
ASSEMBLY
WARNING:
Always be sure that the tool is switched off
•
and battery cartridge is removed before
carrying out any work on the tool. Failure to
switch off and remove the battery cartridge may
result in serious personal injury from accidental
start-up.
Never start the tool unless it is completely
•
assembled. Operation of the tool in a partially
assembled state may result in serious personal
injury from accidental start-up.
1. Nylon cutting
head
1
procedures
described
Installing the front grip
2
012394
Put the front grip on the front grip holder and secure it
with a hex bolt and the clamping nut provided with the
string trimmer as shown in the figure. At this time, the
hex bolt needs to be installed from the side in which the
hex bolt lock port is located and the clamping nut needs
to be installed from the opposite side.
NOTE:
The front grip has a edge-to-edge cut slit in its
•
mounting area. Using this slit allows you to easily
install the front grip on the front grip holder.
The front grip angle is adjustable. To adjust the front
grip angle, loosen the claming nut, set the front grip at
an proper angle according to your work and then tighten
the nut clockwise firmly.
under
Installing the guard
CAUTION:
While installing the guard, be careful not to contact
•
the nylon cord cutter provided on the guard. Contact
with the cutter could result in personal injury.
1
012393
Mount the guard by fitting it on to the motor housing so
that the Nylon cord is not pinched between the guard
and the motor housing, and then secure it with two
screws. Before starting the trimmer, take away the
cutter cover from the cord cutter.
Installing or removing the Nylon cutting head
WARNING:
Before installing or removing the Nylon cutting head
•
(both spool cover and spool, and hereafter called
this way), make sure that the tool is switched off
and the battery cartridge is removed from the tool.
9
1. Front grip
1
2. Clamping nut
3. Hex bolt
3
1. Guard
2. Screws
3. Cutter cover
3
2
Publicité
