Publicité
Les langues disponibles
Les langues disponibles
Battery installation
Fully charge the battery before using it for the first time, full power will lift it over 100 times.
1.
Insert the charger interface vertically into the charging port of the lithium battery and switch it on (Fig. 1)
2.
The charger's indicator light will glow red to show that it is charging
3.
When the lithium battery is fully charged, the charger indicator light will be green
4.
Insert the lithium battery into the battery compartment of the device (as shown in figure 2)
5.
The power display is located in the position shown in Figure 3. To save power, the battery is only displayed while the unit is in
operation. Referring to the power comparison indicator, the lithium battery should be charged when only the red light is on.
6.
Lift the lithium battery after lifting the seat of the device, otherwise the lithium battery may not be removed properly.
It is recommended to buy a spare lithium battery. When using a lithium battery, you can charge another lithium battery and replace it
regularly.
ATTENTION:
Make sure that the surface of the battery is not covered by anything, charging in the bathroom or any other wet place is
not allowed. Dry your hands during the charging process. Only the charger supplied by the manufacturer is allowed to charge the battery.
IDENTITES – Boulevard de la Chanterie – ZA Pôle 49 – 49124 Saint Barthelemy d'Anjou - 02.41.96.18.48
Figure 3 Power indicator
Publicité
